Document Center is acquired by Nimonik

Scope

1.1 This test method covers a procedure for quantifying the intrinsic stability of the asphaltenes in an oil by an automatic instrument using an optical device.

1.2 This test method is applicable to residual products from thermal and hydrocracking processes, to products typical of Specifications D 396 Grades No. 5L, 5H, and 6, and D 2880 Grades No. 3-GT and 4-GT, and to crude oils, providing these products contain 0.5 mass% or greater concentration of asphaltenes (see Test Method D 6560).

1.3 This test method quantifies asphaltene stability in terms of state of peptization of the asphaltenes (S-value), intrinsic stability of the oily medium (So) and the solvency requirements of the peptized asphaltenes (Sa).

1.4 The values stated in SI units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use

Keywords

asphaltenes; compatibility; crude oil; heavy fuels oils; intrinsic stability; S-value; phase separation; residual oil; ICS Number Code 75.040 (Crude petroleum)

To find similar documents by ASTM Volume:

05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)

05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)

To find similar documents by classification:

75.040 (Crude petroleum)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.