ASTM-D6200 › Historical Revision Information
Standard Test Method for Determination of Cooling Characteristics of Quench Oils by Cooling Curve Analysis
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the equipment and the procedure for evaluation of a quenching oil's quenching characteristics by cooling rate determination.
1.2 This test is designed to evaluate quenching oils in a non-agitated system. There is no correlation between these test results and the results obtained in agitated systems.
1.3 The values in SI units are to be regarded as the standard. The values in parenthesis are provided for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
cooling curve; cooling rate; cooling time; quench oil; ICS Number Code 75.080 (Petroleum products in general)
To find similar documents by ASTM Volume:
05.02 (Petroleum Products and Lubricants (II): D3711 - D6122)
05.03 (Petroleum Products and Lubricants (III): D6138 - D6971)
05.04 (Petroleum Products and Lubricants (IV): D6973 - latest)
To find similar documents by classification:
75.080 (Petroleum products in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D6200-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 10, 1997
Document Type
Test Method
Page Count
5 pages
Committee Number
D02.L0.06